Konica-minolta BIZHUB 223 Manual do Utilizador descarregar pdf (Página 68)

bizhub 423/363/283/223 5-12

5.1 [Basic]

[Offset] [Yes]/[No] Specify whether to separate each set of copies from another set in the output

tray when copying multiple sets of multi-page originals.

When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is not

installed:

If the following conditions are met, printed copies are fed out and sorted in an

alternating crisscross pattern.

• The 8-1/2e11, A4, or B5 size paper is used

• Paper of the same size and type is loaded with the w orientation in one pa-

per tray and with the v orientation in another tray

• Auto paper selection is specified for the paper size setting

When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is in-

stalled:

The copies are fed out and stacked on top of each other with each set shifted

to separate it.

[Fold/Bind] Staples copy outputs in the center the paper or fold them in the center before

discharging.

[Half-Fold] [Center Staple & Fold]

[Staple] Staples copies in corner or at two points before they are output.

[Punch] Punches holes in copies before they are output.

[Position Setting] Configure desired staple or hole-punch positions.

Select Auto, and the machine automatically judges the staple or punch posi-

tions for the paper relative to the original direction loaded.

• A staple or punch position along the long side of the paper is selected if the

original length is 11-11/16 inches (297 mm) or less.

• A staple or punch position along the short side of the paper is selected if

the original length exceeds 11-11/16 inches (297 mm).

• Staple or punching positions are set on the upper or left-side end.

• Be sure to load the original so that its top side is placed in the back.

• If desired, press [Original Direction], and then select the original direction.

Settings

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 265 266

Sem comentários

Konica-minolta BIZHUB 223 Manual do Utilizador Página 68